^

A-MIMO-1 in situ A-MIMO-1 in situ A-MIMO-1 Rearview Connectors A-MIMO-1 A-MIMO-1 A-MIMO-1 Package Contents

v

<<

>>

Click the image to enlarge

A-MIMO-1

Poynting 5-in-1 MiMO LTE/GPS/WiFi Antenna

  • 2 x MiMo Wi-Fi dual band
    2 x MiMo LTE
    1 x GPS & GLONASS
  • Operating Frequency:
    690-960 MHz,
    1710-2700 MHz,
    1600 MHz (GPS/Glonass),
    2400-2500 MHz (WiFi),
    5000-5800 MHz (WiFi)
  • Network operator flexibility - as the antenna is wideband, a new
    antenna is not needed per network operator - works on most networks
  • The GPS/Glonass antenna and electronics operates down to -40
    degrees and up to 70 degrees C which is seldom achieved in
    comparable products.
  • Vandal and water resistant

Buy Now

A-MIMO-1

Buy Now

A-CAB-118

LMR195-FR 5 x 5m cable
Connectors antenna side: 5 x SMA Socket
Connectors Modem/Radio side: 3 x SMA Plug & 2 x RPSMA Plug
Cable is a Non-halogen (Non toxic), Low Smoke, Fire Retardant cable

Overview

The MIMO-1 incorporates 5 antennas in a single rugged low profile antenna housing. Two LTE/4G/3G antennas covering all cellular bands and also achieves MIMO data speed increases since the two antennas provide space and pattern diversity. Similarly two dual band Wi-Fi antennas give blistering speeds at both 2.4 and 5GHz and full MIMO advantage. The fifth antenna is a high performance active GPS/GLONASS module operating down to -40 degrees.

The antenna exceeds the performance of most competitors due to the care and attention to radiation patterns of all radiators. An excellent compromise between omni-directionality, pattern diversity and good radiation at low (horizontal) angles is achieved. Main applications are for industrial vehicles, M2M and other IoT using a range of radio technologies. Whilst this antenna is predominately marketed for industrial purposes it could quite easily be used on a motorhome, caravan or barge, particularly if you were looking for a more permanent installation than the portable antenna we offer.

Application areas
• 4G to Wi-Fi internet on buses, trains etc
• Linking public vehicles to data networks
• Trucks, tractors and other industrial vehicles for control and communications
• M2M to ATMs, vending machines, modems, smart meters, industrial enclosures
• Asset tracking (containers etc)

Read our article - 'Antenna Considerations for 4G/LTE'

Case Study: Touring Book author replies on his Poynting Antenna to improve marginal reception while on tour in his motorhome - click here to read the article

Specification

Download Specification Datasheet including polar plots

 

Download presentation for the MiMo1 family
GSM/3G/LTE electrical specifications Frequency Band 1: 690 - 960MHz
Frequency Band 2: 1710 - 2700MHz
Gain (Max): 3 dBi
VSWR: <2.5:1
Feed Power Handling: 10 W
Input impedance: 50 Ohm (nominal)
Polarisation: Linear Vertical x 2
Cable loss: 1000MHz - 0.4dB/ 1/2 m
3000MHz - 0.8dB/ 1/2 m
DC Short: Yes
GPS/Glonas Antenna electrical specifications Frequency Range (GPS): 1575.42MHz/1600MHz
Gain (Max): 21+/-2dBi
VSWR: ≤1.5:1
DC Voltage: 2.7-3.3 V
DC Current: 5-15mA
Noise Figure: ≤1.5 dB
Nominal Impedance: 50 Ω
Polarisation: RHCP
Filter Out Band Attenuation: 12dB Min f0+50MHz,
16dBi Min f0-50MHz
Cable: 0.5m EF_316_D
Connector: SMA (M)
Voltage: 2.7 - 3.3V
Max. Power-W: 50W
Wi-Fi electrical specifications Frequency: 2400-2500 MHz
5000-5800 MHz
Gain (Max): 3.5 dBi (2dBi nominal)
VSWR: < 2:1 @2.4-2.5GHz
< 3:1 @ 5.1-5.8GHz
Feed power handling: 10 W
Nominal input impedance: 50 Ohms
Polarisation: 2 x Vertical linear
Environmental Specifications Wind Survival: 160 km/h
Temperature Range (Operating): -40°C to +70°C
Environmental Conditions: Outdoor/Indoor
Operating Relative Humidity: Up to 98%
Storage Humidity: 5% to 95% - non condensing
Storage Temperature: -40°C to +70°C
Certification Approvals and Standards Cable Flammability rating: UL 94 V1
EN13823
Water Ingress Protection Ratio/
Standard:
IP 65 (NEMA 4X)
Impact resistance: IK 10
Salt Spray: MIL-STD 810F/ASTM B117
Product Safety: Complies with UL, CE, EN, CSA and IEC
Connectors

2G/3G/4G MiMo antenna cable (30cm) :
Maroon label
SMA plug connector


GPS/Glonass antenna cable:
Blue Label
SMA Plug connector

2.4/5GHz MiMo antenna cable:
Green Labels
SMA Plug connector (2 x adapter included for Reverse SMA)
Product Dimensions (L x W x D): 252 mm x 127 mm x 55 mm
Downloads
E Mark Test Results and Certificate

Test Results

Statement of Conformity Certificate

 28.04.17
High Resolution Images Download here 04.11.16
Product Sales Leaflet Download here 04.11.16
Reviews
Brochures
Videos
Solwise Video

Unboxing and Product Overview

Antenna Considerations for 4G/LTE

Objective
To try and clarify factors that you need to consider when planning on using an external antenna for your 4G/LTE broadband connection.
With 4G (LTE) services starting to come onto the UK market a lot of users are finding that they are achieving download speeds that are lower than they were expecting to get. Often this can be due to poor reception however there are other factors that need to be understood which can affect the broadband speed.

Hopefully this short article will help explain the implications and considerations the user needs to examine before they can decide the best course of action. Click here to read more

Guest Post - Choosing between a directional or an omni antenna, by Stephen Froneman of Poynting

Guest Post - Choosing between a directional or an omni antenna, by Stephen Froneman of Poynting

The choice of omni-directional and directional antenna is not always simple. We will try to explain the key differences experienced by using a uni-directional (aka ‘directional’) antenna vs. an omni-directional (aka ‘omni’) antenna.
Accessories

<

>

X