NET-WAP-654GP
Pheenet High Power Access Point
- IEEE802.11g 54Mbps 200mW
- Client, Repeater, P2P, PMP
- Detachable Antenna : Reverse SMA Connector
- Realtek Chipset
- Power over Ethernet Built-in
NET-WAP-654GP
Overview
The PheeNet WAP-654GP is an IEEE 802.11g 54Mbps High Power Access Point / Bridge. The WAP-654GP has WEP and also advanced WPA, WPA2, IEEE802.1x, Disable SSID Broadcast, MAC Address filtering to ensure the security of Wireless LAN.
The WAP-654GP is equipped with a 2dBi Dipole Antenna which is removeable. It has a Reverse SMA Connector. The WAP-654GP's High power enables you to build a convenient, efficient wireless network.
The WAP-654GP can be set as Access Point, Bridge, Client and Repeater.
Specifications
|
|
|---|---|
| Download Specification Datasheet | |
| 6 Operation Modes : Access Point, Repeater(WDS) ,Bridge, Client Bridge, Point-To-Point, Point-To-Multi-Point Support AP/Bridge Mode simultaneously Fully Backwards Compatible with all 802.11b Wireless Network 54Mbps, Up to 5X Faster than 802.11b Products Support 200mW High Power Support Power Over Ethernet Wireless Distribution System(WDS) when running in Repeater mode Maxmum Wireless Security with 802.1x, WPA, and AES Maxmum Internet Security with IPSEC (DES,3DES,AES-128) Support TPC Support Signal Strength |
|
| Industrial Standard | |
| Standard | IEEE 802.11g IEEE 802.11b IEEE 802.11 IEEE 802.3u 100Base-TX Fast Ethernet ANSI/IEEE 802.3 N-way Auto-Negotiation |
| Interface | 100/10 Base-TX (RJ-45) x 1 |
| Security | 802.1x, WEP,WPA TKIP, WPA2 AES/Mixed mode for PSK and TLS(Radius) WDS supported with WEP,TKIP and AES encryption Wireless access control by MAC address (deny or accept) |
| RF | |
| Frequency Band | 2.412~2.472 GHz ISM band |
| Signal Type & Modulation | 802.11g: OFDM (64QAM, 16QAM, QPSK, BPSK) 802.11b : DSSS(CCK, DQPSK,DBPSK) |
| Antenna | 1 x detachable Antenna (Reverse SMA Connector) |
| Output Power | 200mW |
| Transmit Power Variation | 100%, 50%, 25%, 10%, 5% |
| Sensitivity | 802.11b 1Mbps: -91dBm, 2Mbps: -90dBm, 5.5Mbps:-89dBm, 11Mbps:-87dBm 802.11g 6Mbps:-84dBm, 9Mbps:-82dBm, 12Mbps:-79dBm, 18Mbps:-77dBm, 24Mbps:-75dBm, 36Mbps:-73dBm, 48Mbps:-70dBm, 54Mbps:-68dBm |
| Channels | By Country (IEEE802.11d) |
| Operating Mode | AP Mode : 802.11b/g Access Point(AP) Repeater Mode: WDS Repeater , Universal Repeater Bridging Mode : P2P, PTMP, Client Mode : Ad-Hoc and infrastructure mode Support Radius client used in client mode Support site survey scan and manual connect Support MAC Clone |
| Management | Web configuration |
| Hardware | |
| POE | Splitter of POE Built-in |
| Base Platform | RL8186+ RL2560 (MIPS R3000 ISA-1 ) |
| Clock Speed | 200 MHz |
| Reset Switch Built-in | Push-button momentary contact switch |
| SDRAM | On board : 8Mbytes |
| Flash | On board : 2Mbytes |
| Built-In LED Indicators | Power Status always On / Blinking: while upgrading firmware Ethernet On: Blinking: Active Wireless Blinking : Active |
| Environment | Operating Temperature:0~50C Storage Temperature:0~70C Humidity: 5%~95%(non condensing) |
| Power Supply | 12 VDC, 1A input |
| Dimensions | 112 (L) x 73(W) x 31(H) (mm) |
